Skip to content

ENA3-NSE device


    The ENA3-NSE consists of a pre-wired and pre-assembled ENA3 controller, a 24V power supply and battery backup (NSE).

    It guarantees an uninterrupted supply of power for the control unit ENA3 and the 24V trigger coil of the actuator (A3 brake element). This prevents an unintended action of the actuator caused by a power failure.

    [expand title=”Facts” trigclass=”exp-but” rel=”des-highlander”]

    • 24V uninterruptible power supply for the ENA3 and the coil of the actuator (A3 brake element)
    • Actuator falls during a power failure until after about 5 seconds
    • Battery charger with low voltage protection and battery monitoring: Battery is charging and being monitored during normal operation
    • Emergency Rescue: By pressing the emergency button the battery is activated and supplies the ENA3 and the coil of the actuator 24V for 15min. During this time, the lift can be used for a rescue.

    Battery: 12V 1,2 AH

    Power Supply NSE: 110 – 230 V AC +/- 10%

    Plastic housing IP65 incl. RESET button

    Dimensions: 275mm x 225mm x 120mm (LxWxH)

    Order Codes

    • ENA3-NSE-BOX
      ENA3 UMC with NSE for trip coil voltage 24 V
    • ENA3-NSE-12-BOX
      ENA3 UMC with NSE for trip coil voltage 12 V
    • ENA3-NSE
      ENA3 UMC with NSE for trip coil voltage 24 V on DIN rail
    • ENA3-NSE-12
      ENA3 UMC with NSE for trip coil voltage 12 V on DIN rail
    • MAG-BAND-020
      Magnetic tape for doorzone
    • MAG-BAND-BEF
      Mounting kit for magnetic tapes
    • MS-KIT
      Magnetic switches with mounting kit